Generate center space nacelles

Open e.g.: the Tego catalog and read in the following assemblies.

Assembly of the first page

  1. Socket assembly S1647CS
  2. Backplane assembly GL1612CSG
  3. Shelf assembly MB147C | Parameter: vo=0.4/0.7
  4. Shelf assembly MB137C | Parameter:vo=1

Placement of the second side


In the catalog window, click on the "place" Symbol
In the context menu that appears, click on "Settings Placement"
Apply the following settings:

  • Depth offset: 6×3
  • Height offset: 0
  • Rotation angle: 180
  • Axle dimension: 1

 

Socket assembly: S1647CS

Click on the placement icon again. Select "Apply placement" in the menu that opens. The base is then read in on the back.
Shelf assembly: MB147C
Select the placement icon again and select Create parameter at this point. The following parameter is now displayed in the catalog window.

  • Parameter: vt=-0,06vw=180vr=-1
  • Add the following values to this:
  • vo=0.4/0.7

Shelf assembly: MB137C
"Create parameter" and add the parameter with:
vo=1
The settings for column depth and rotation angle are saved.

Alternative way: Placement of the second side

  1. Next, select the assemblies you just created and go to the right in the "Start" tab; there, select "Hide Others".
  2. Now you can see only the nacelle you just created. This makes it easier for you to edit the nacelle.
  3. Now switch to the "Right" workspace and maximize it.
  4. Now select all the shelves and the plinth from top right to bottom left. As you can see, the selection frame is now green. Please select the components as shown in the picture on the right.
  5. Go to the "Edit" tab and select "Mirror". Move the mouse to the bottom right point of the column and click the left mouse button. Then press [CTRL] and move the mouse to the left.
  6. Now release the [CTRL] key and press the left mouse button again. The object is now mirrored and highlighted in green. Now move it 6 cm to the left.
  7. Now select the entire section and assign the group name "Standard middle room gondola" in the "Shopfitting" tab. Then switch to the workspace at the top and move the section slightly to the right.