Generate center space nacelles

Open e.g.: the Tego catalog and read in the following assemblies.

Assembly of the first page

  1. Socket assembly S1647CS
  2. Backplane assembly GL1612CSG
  3. Shelf assembly MB147C | Parameter: vo=0.4/0.7
  4. Shelf assembly MB137C | Parameter:v o=1

Placement of the second side


In the catalog window, click the place Symbol
In the context menu that appears, first click on Settings placement
Apply the following settings:

  • Depth offset: 6×3
  • Height offset: 0
  • Rotation angle: 180
  • Axle dimension: 1

Socket assembly: S1647CS
Click on the placement icon again, in the menu that opens, select Apply Placement. This will read the pedestal on the back side.
Shelf assembly: MB147C
Select the symbol for placement again and select Create parameter at this point. Now the following parameter is displayed in the catalog window.

  • Parameter: vt=-0,06vw=180vr=-1
  • Add the following values to this:
  • vo=0.4/0.7

Shelf assembly: MB137C
Create parameter and complete the parameter with:
vo=1
The settings for column depth and rotation angle are saved.

Alternative way: Placement of the second side

  1. Next, select the assemblies you just created and go to the right in the "Start" tab; there, select "Hide Others".
  2. Now you can see only the nacelle you just created. This makes it easier for you to edit the nacelle.
  3. Now switch to the "Right" workspace and maximize it.
  4. Now select all the shelves and the base from top right to bottom left. As you can see, the selection frame is now green. Please select the components as shown in the picture below.
  5. Go to the "Edit" tab and select "Mirror" there. Move the mouse to the lower right point of the column and click the left mouse button. Then press [CTRL] and move the mouse to the left.
  6. Now release the [CTRL] key and press the left mouse button again. The object is now mirrored and marked in blue. Now move it 6 cm to the left.
  7. Now select the entire section and assign the group name: "Center nacelle standard" in the "Shopfitting" tab. Then switch to the workspace at the top and move the section slightly to the right.